Hy-Tower 8' x 28' Black Mesh Tarp with Flaps

Hy-Tower Replacement Tarp With Flaps: 8 ft × 28 ft Black Knitted Mesh

Replace the flap-equipped cover on a compatible Hy-Tower system with part 1801020, previously identified as 2963. This black knitted mesh tarp is listed at 8 ft wide × 28 ft long for the 22-foot-container application. DeBrovys identifies the item as SKU 20-2963/1801020. It is a finished replacement tarp with flaps, not a complete tarping system, hydraulic kit or replacement roller assembly.

The part number matters because Hy-Tower also uses a different standard knitted mesh cover without this flap designation. Match the existing equipment specification and tarp configuration before ordering. A 22-foot container does not take a 22-foot-long tarp in this listing: the specified tarp length is 28 feet.

Specifications for Hy-Tower Tarp 1801020

The manufacturer's 96-inch width identifies the tarp body. Do not assume that it represents an overall measurement across extended flaps. If flap reach or the finished overall width determines fit, confirm those details against the current replacement specification before ordering. Fabric basis weight, denier, cold-crack rating and fire-retardant certification are not established by this part's replacement listing.

Choose the With-Flaps Tarp, Not the Standard 1801026 Cover

The most important comparison is between this 1801020 / 2963 with-flaps tarp and the separately listed 1801026 / 2978 standard Hy-Tower knitted mesh tarp. The with-flaps version is listed at 8 ft × 28 ft. The standard version is listed at 8 ft 4 in × 28 ft. Both are black knitted mesh replacements associated with 22-foot containers, but they are not the same part.

For example, a maintenance record calling for 2963 should lead you to this 1801020 replacement, not to the wider standard tarp merely because its product photo looks familiar. An installed-system photograph shows the type of equipment in use; it does not prove a particular flap layout or end attachment. Use the part number and configuration as the deciding references.

If the original part number is unreadable, photograph the existing tarp edges and attachment points and record its dimensions using a safe measurement method. Give those details to DeBrovys before substituting a different cover. Avoid using the condition of a stretched, torn or previously modified tarp as the only specification.

What Black Knitted Mesh Provides

The published Hy-Tower material description identifies knitted black mesh as rip resistant and gives a 70% shade rating. That figure describes shade, not a certified containment efficiency or load rating. The open mesh structure is also not a waterproof barrier. Do not select this replacement as a solid rain cover or assume it meets a material-retention requirement solely because of the shade percentage.

Keep the replacement choice tied to the installed system and the material being hauled. If the operation needs a solid cover or a different containment configuration, confirm the appropriate equipment-compatible product rather than transferring vinyl specifications onto this mesh item. Flaps distinguish its cover configuration; they do not change the mesh into waterproof fabric.

Browse Waste Industry Tarps to compare the broader range of waste-covering applications. For other truck and trailer uses, visit Truck Tarps. These routes help separate a system-specific replacement from manual throw tarps and other covers with different attachment requirements.

Ordering and Replacement Checks

Before placing the order, verify part 1801020 or the older 2963 number, the 96-inch body width, 28-foot tarp length and with-flaps configuration. Then check the cover's end attachments against the equipment instructions. Do not infer a particular pocket size, spline, grommet spacing, webbing layout or included fastener kit from a generic dump-truck tarp description.

Inspect the equipment for damaged attachment points, rough contact surfaces or an operating problem that may have contributed to the old cover's failure. Replacing the fabric does not correct those problems. Follow the system manufacturer's shutdown and maintenance procedures, and use a qualified service provider when the work requires one. This page identifies the replacement part; it is not an installation manual.

The separate Hy-Tower waste tarp system page provides equipment context if you need a complete system rather than a replacement cover. For a fleet with multiple configurations, record the replacement number alongside the truck or system identifier so the next order is not based only on container length.

Read the roll-off truck tarp-system guide for broader selection context. Confirm current availability and delivery arrangements before scheduling equipment downtime; this listing does not promise a particular dispatch date or free shipping.

Frequently Asked Questions About the Hy-Tower Tarp With Flaps

Which part number is this tarp?

This page is replacement part 1801020, with the previous reference 2963. The DeBrovys SKU is 20-2963/1801020. It is the flap-equipped black knitted mesh version, not standard part 1801026.

Is the listed width 8 feet or 8 feet 4 inches?

The manufacturer lists this part at 8 ft × 28 ft and identifies a 96-inch body width. The 8 ft 4 in × 28 ft standard cover is the separate 1801026 part. Confirm overall flap measurements if they are critical to the installation.

Why is a 28-foot tarp listed for a 22-foot container?

The container length and tarp length describe different dimensions in the manufacturer's application table. This tarp is 28 feet long and is listed for the Hy-Tower 22-foot-container application. That listing is not a universal-fit guarantee for every 22-foot box or tarping system.

Is knitted mesh with flaps waterproof?

No waterproof performance is claimed for this open mesh cover. Its published properties are rip resistance and 70% shade. If moisture protection is required, ask about a suitable system-compatible alternative rather than treating the flaps as a waterproof seal.

Does the purchase include a Hy-Tower system?

No. This is one fixed-size replacement tarp. The truck, container, roller assembly and complete system are not included. Match the part number and attachment configuration before ordering.

Order the Hy-Tower tarp with flaps when 1801020 / 2963 matches your equipment. For fitment assistance, call DeBrovys at 502-584-3352 or contact DeBrovys. If the standard replacement does not meet the job requirements, ask whether custom fabrication is appropriate. Any sewn construction or heat-sealed panel option must be confirmed for the selected fabric and equipment; neither is assumed for this knitted mesh replacement.